SINGLE-SPHERE FLEXIBLE RUBBER JOINT WITH FLOATING FLANGES
Manufacture : Gala
Applications
This product is mainly applicable for piping system in commercial and industrial buildings and plants.
Applicable fluids are exclusively water including cold water, warm water, sea water, etc.
This product can not be used for drinking water, pool water, oil or boiled water.
Materials
Note :
Flanges on ANSI, BS, etc. available
The flange material can be changed to Mild Steel, SUS 306 and SUS 316
JIS 16K/ JIS 20K Flanges are all Mild Steel (32-600)
Technical Parameter
Dimensions and Allowable Movements
T.M = Transverse Movement A.E = Axial Elongation A.C = Axial Compression A.M = Angular Movement
TWIN-SPHERE RUBBER JOINT WITH FLOATING FLANGES
Manufacture : Gala
Typical Applications
Cold and warm water pressure piping systems in commercial and industrial buildings and plants.
Pump and turbine piping used for power generation plants, industrial machinery and pump blowers.
Feed-water and drainage piping for water, wastewater and sanitary system.
This product is not applicable for use with oil, air gases, hot water supply lines and with pool water.
Materials
Note :
Flanges on ANSI, BS, etc. available
The flange material can be changed to Mild Steel, SUS 306 and SUS 316
JIS 16K/ JIS 20K Flanges are all Mild Steel (32-600)
Technical Parameter
Dimensions and Allowable Movements
T.M = Transverse Movement A.E = Axial Elongation A.C = Axial Compression A.M = Angular Movement
SCREWED TYPE
Manufacture : Gala
Applications
Vibration isolation for small pump and circular pumps
Sewage disposal purifier line
Vibration isolation for air-conditioners and pipes
not suitable for hot water
Materials
Dimensions and Allowable Movements
T.M = Transverse Movement A.E = Axial Elongation A.C = Axial Compression A.M = Angular Movement
Explain :
Axial Axial Angular Transverse
compression elongation movement movement
- Mass indicates only the case with JIS 10K flanges
- Products should be used within the given allowable movements only
- Tolerances for installation are included in the allowable movements
(Allowable Movements = Tolerances for instalation + Operating Movements)
Post a Comment